Experimental 12Volt Lycoming starter 12V149HTS
Featuring Kickback Protection our 12V149HTS starters fit all experimental Lycoming powered aircraft. High duty cycle capabilities and durability on even the hardest starting 12V aircraft. A great replacement starter for all non-geared, opposed Lycoming engines. At only 9.4 lbs., this starter is the lightest Bendix-free starter available. Our remanufactured starter get the same two-year warranty as the OEM model.
This starter is better suited for the higher compression larger displacement engines.
NO core required.
For 149 tooth flywheel with 12/14 pitch
Experimental use only.
24volt model available by special request
No certified PMA models available
Even though we are NOT an FAA repair station, we can take your Flightwidgets HTS or OEM starter and rebuild it for 12Volt experimental use. OEM starters will be rebranded and marked "For Experimental Use Only"
Ship to: Flightwidgets, 3803 Hemlock Ct, Rockford, IL 61107
Can't wait? Got one sitting on the shelf? Send it to us and get a $150 credit once we receive it and determine its rebuildable.
Ship to: Flightwidgets, 3803 Hemlock Ct, Rockford, IL 61107
24V only unit. Used and tested good, 1 year warranty. Your A&P must determine suitability and airworthiness for your application
HTS 12V motor assy
Replacement 12volt motor for HTS starters. Built with all new parts.
Fits OEM NL and HT starters. Experimental use only.
HTS 12V solenoid kit with plunger, recoil spring and new contacts
This kit is the minimum you will need to bring your starter back to life if everything else is good. Fits our HTS as well as OEM NL and HT starters. Experimental use only
1x New 12Volt motor
1x New plunger with spring
1x New L/R contacts
2x solder tabs
Fits OEM NL and HT starters
Experimental use only
12volt solenoid kit. Soldering of the coil leads is required. Fits our HTS as well as OEM NL and HT starters. Experimental use only
1x New 12Volt motor
1x new 12Volt solder in solenoid coil
1x New plunger with spring
1x New L/R contacts
2x solder tabs
Fits OEM NL and HT starters
Requires soldering
Experimental use only
Fits Flightwidgets HTS and NL starters
Includes:
New motor assembly
New 12V solenoid coil and plunger with spring
New 11 tooth gear drive assembly for 149T flywheels
Secondary shaft bearing and 2x shear pins
Rubber plug for jumper wire hole
2x copper terminal bolts, plastic grommets, o-rings, lock washers and nuts for power leads
Motor thru-bolts available upon request